Cutting Steam Stopper
Cutting Steam Stopper to suit your shower is very easy.
We are making videos to show the steps that are needed in cutting the steam stoppers, please click on the video to watch.
Cutting Steam Stopper using a router.
We have also found that any “Flush Fit Trim Router Bit” also works well.
The Ball Bearing is on the bottom rather than the top. as per the image below.
Cutting Steam Stopper using a scoring tool.
When using the scoring method shown above please make sure you have cut over
80% of the way through before you try to snap the excess off.
You can purchase a Steam Stopper from any of the Resellers to the right and install it yourself.
Steam Stopper Installation Instructions
Watch the Installation Video here
To download these instructions right hand click and choose ‘save as’
*take note where you are saving it*
